Liberty Loop vaginal catheter: Ideal for controlling urinary incontinence and strengthening pelvic floor muscles

The intravaginal probe Liberty Loop is intended for the treatment of incontinence female urinary tract through the muscle stimulation and an EN60601-01 approved electromyographic biofeedback equipment.

Important:

- For personal use only

- It can be used by the same patient.

- Wash before first use.

- Do not use if the container is open or damaged.

Contraindications:

Do not use the Muscle Stimulator in the following cases:

- An implanted pacemaker may alter the proper functioning of the device.

- Pregnancy, the influence on the fetus is unknown.

- Vaginal or bladder infection, or a recent surgical scar; the introduction of the catheter may aggravate the infection.

- With a history of carcinoma at the stimulation site, laboratory tests show that electrical stimulation can increase cell division.

Caution is advised in the following cases:

- In patients with altered or reduced sensitivity of muscle tissue, excessive stimulation may result in tissue inflammation.

- In patients with a history of epilepsy, the use of electrical stimulation may lower the seizure threshold.
Product lifespan in use: 6 months

Cleaning:

The Liberty electrode is intended for use by a single patient.

Before first use and after subsequent uses, the appliance must be cleaned as follows:

Wash the electrode, including the cable, in warm soapy water. Rinse with clean water.

Dry the electrode with a clean cloth/paper towel and leave out until completely dry, before replacing it in the plastic bag.

DO NOT IMMERS in liquid.

DO NOT USE boiling water.

Waste disposal

Clean up and dispose of in accordance with local regulations.

Instructions for use:

1. Remove the electrode from the package and clean it.

2. Insert the cable into the slot inside the probe.

3. Apply a thin layer of lubricant to the electrode, and insert it until the tab at the base of the electrode rests between the vaginal lips.

4. Ensure that the muscle stimulator or electromyographic biofeedback equipment is switched off, and connect the device to the electrode through the connector ends.

5. Follow the manufacturer's instructions regarding the use of the stimulator or biofeedback unit.

6. After use, turn off the device, disconnect the electrode cable and clean as indicated above.

Biofeedback pointer

You can attach the pointer to the base of the loop to show the effect of the correct muscle contraction.

It can be used with stimulation or to assist voluntary Kegel exercises.

During a correct contraction, the pointer should move downwards.

Average usage time of probes (anal and vaginal)

Durability: Provided they are used exclusively on a single patient, cleaned using a gentle washing method, and stored in dry conditions, they should last at least 3 years; the limiting factor will be mechanical damage to the connecting cables.